Estate EED4300VQ0 user manual download

You can view the full version and download it in PDF format.
Page 3 of 28
WARNING:
For your
safety,
the information
in this
manual
must
be followed
to minimize
the
risk of
fire
or
explosion,
or to prevent
property
damage,
personal
injury,
or death.
- Do not store or use gasoline or other
flammable
vapors and liquids in the vicinity of this
or any other appliance.
- WHAT
TO DO IF YOU
SMELL
GAS:
Do not try to light any appliance.
Do not touch
any electrical
switch;
do not use any
phone
in your
building.
Clear
the room,
building,
or area
of all occupants.
Immediately
call
your
gas supplier
from
a neighbor's
phone.
Follow
the gas supplier's
instructions.
If you
cannot
reach
your
gas supplier,
call the
fire
department.
- Installation
and service must be performed by a qualified installer, service agency, or
the gas supplier.
Your dryer must be properly
installed and vented
to achieve
maximum
drying efficiency
and shorten drying times. Use the
minimum
recommended
installation
clearances
found
in the
Installation
Instructions.
See the Installation
Instructions
for more
information.
Fire Hazard
Use
a heavy
metam vent.
Do not
use a pmastic vent.
Do not
use a meta_ foil
vent.
Failure
to fo_mowthese
instructions
can
result
in death
or fire.
If the dryer is not properly
installed and vented, it will not be
covered
under the warranty.
Proper venting
of your dryer is
important
for satisfactory
drying results. See the Installation
Instructions
for more detail.
NOTE: Service calls caused by improper
venting
will be paid for
by the customer,
whether
it was a paid installation
or self-
installed.
Do not use plastic vent or metal foil vent. Use 4" (10.2 cm)
metal or flexible
metal vent. Do not kink or crush flexible
metal
vent. It must be completely
extended
to allow adequate
exhaust
air to flow. Check vent after installation.
Refer to the
Installation
Instructions
for proper length
requirements
of vent.
2.
Use a 4" (10.2 cm) exhaust
hood.
3.
Use the straightest
path possible when routing the vent.
Good
Better
4=
5.
Use clamps to seal all joints.
Do not use duct tape, screws
or
other fastening
devices
that extend into the interior of the vent
to secure vent.
Clean exhaust
vent periodically,
depending
on use, but at
least every 2 years, or when installing
your dryer in a new
location.
When cleaning is complete,
be sure to follow the
Installation
Instructions
supplied
with your dryer for final
product
check.
Sample