You can view the full version and download it in PDF format.
Page 8 of 162
For your own safety and to prevent unnecessary damage to your device,
read and comply with the following safety instructions:
Proper use and environmental conditions
This TV set is designed exclusively for reception and reproduction of
video and audio signals and is designed for living rooms or office facilities,
and should not be operated in rooms with high
, such as a
bathroom, or sauna, or where there is a high
concentration of dust
workshops). The manufacturer‘s warranty is only valid for use in the specified
If the set is used outdoors ensure that it is protected against
(rain, splashing water, or dew). High humidity and dust concentrations
cause leak currents in the device, which can cause a shock hazard if the
device is touched, or a fire.
If you have brought the set into a
warm environment from the
then wait for about 1 hour before
switching it on to avoid formation of
Do not place any
on top of the appliance. Pro-
tect the appliance against dripping
and splashing water.
must be kept
away from the appliance at all times
to prevent it from catching fire.
Never place the TV set in a position where it is exposed to
can lead to material overload.
Only transport the device in
. Grasp the device on the
upper and lower edges of the housing. Never put the TV set down on
the control unit with the control unit projecting on the bottom. This could
damage the control unit.
If the set has to be put down during packing/unpacking, place the TV
set with the entire front surface lying flat on a soft underlay such as a
blanket or the felt from the packing material.
The LCD screen is made of glass or plastic and can break if not handled
Always wear rubber gloves to carry the TV set if the LCD screen is dam-
might be leaking out. In the case of
immediately wash thoroughly with water.
can damage the set. This equipment must only be
connected to a mains power supply which has the same voltage and
frequency as that specified on the rating plate; use the mains cable
of the TV set must be easily accessible so that
the device can be disconnected from the mains at any time. When you
unplug the mains plug, do not pull on the
rather pull on the plug
housing. The cable in the mains plug could be damaged and cause a
the next time it is plugged in.
Lay out the
in such a manner that it cannot be damaged.
The mains cable must not be kinked or laid over sharp edges, stepped
on or exposed to
; The latter also applies for the entire equip-
ment. A mains cable with damaged insulation can cause
and is a
Air circulation and high temperatures
of the set must always be kept free.
Please do not place newspapers or cloths on/over the TV.
Ensure that there is at least 10
cm free space on the sides and
above the set for air circulation,
if the set is placed in a
or on a
Like any electronic device, your
TV set requires air for cooling.
Obstruction of the air circula-
tion can cause fires.
paper clips, liquids, wax, or
similar items, from getting into the interior of the device through the
in the rear panel. Such objects can cause
set, which could possibly cause a fire.
If something should get into the
interior of the set
unplug the mains plug of the device and contact
Automatic shutdown (only in Home Mode)
If the TV is not operated for 4 hours (adjustment of volume, programme
change, etc.) the TV will automatically switch to stand-by mode to save
energy. A prompt to terminate this shutdown process appears one min-
ute before expiry of the 4 hours. The automatic shutdown is only active
in the energy efficiency mode
. Automatic shutdown does
occur when using the radio
screen display (
For your safety