Loewe Individual 46 Selection LED 200 user manual download (Page 63 of 162)

Languages: English
Pages:162
Description:Телевизор
You can view the full version and download it in PDF format.
Page 63 of 162
63 -
english
Conditional Access module (CA module)
In order to receive coded digital stations, a Conditional Access module
(CA module) and a Smart Card must be inserted in the CI slot of your TV
set (see page 11).
The CA module and the Smart Card are not part of the TV set’s scope
of delivery. They are usually available from your dealer. Loewe does not
provide any guarantee for the functioning of the CA module.
The TV set must first recognise and set up the CA module during initial
operation. Therefore, it can take up to a minute until decoding starts
during initial operation.
Inserting the Smart Card into the CA module
Push the Smart Card into the CA module as far as it will go. The side of
the card with the gold chip on it should be pointing towards the thicker
side of the insertion slot (see illustration). Observe the direction of the
arrow printed on the SmartCard.
Inserting the CA module into the TV set’s CI slot
Switch off the TV set’s mains switch.
Remove the cover from the rear of the set.
Insert the CA module carefully into one of the two CI slots, ensuring that
the contact side goes in first. Do not use any force when pushing it in.
Make sure that the module does not go in at an angle. Push the CA
module in as far as it will go.
For Loewe TV sets, CI slots can be built in with an ejector (A) or without
an ejector (B). In the case of CI slots
with
an ejector, this protrudes
slightly out from the unit when the CA module is correctly installed.
Finally, close the side cover.
Coded Stations
Searching for encrypted stations
The search wizard must only be started if the setting
option
no
has been selected during first installation in
the search for encrypted stations and no CA-module
was inserted.
MENU:
Call
TV menu
.
±²
Select
Settings
,
´
go to the menu line below.
±²
Select
Stations
,
´
go to the menu line below.
±²
Select
Search wizard
,
´
go to the menu line below.
±²
Select
Change search settings
,
OK
wizard guides you through the search settings.
See page 44 for a description of the search settings.
Calling CA module information
This menu is only available for digital stations and when
a CA module is plugged in.
MENU:
Call
TV menu
.
±²
Select
CA module: xxx
,
OK
call information.
The content of this menu depends on the provider of the
CA module.
The CA module information can also be called up in the
TV menu
under
Settings
ט
Other
ט
CA module: xxx
(xxx
corresponds to the CA module provider).
Removing the CA module
Switch off the TV set’s mains switch.
Remove the cover from the rear of the set.
For CI slots
with
an ejector (A), press the ejector button on the corre-
sponding module slot and the CA module will be released. Pull the CA
module out of the unit.
For CI slots
without
an ejector (B), just pull the CA module out of the CI
slot.
Replace the cover.
Smart Card
CA module
Contact side
(A)
(B)
Sample