Marantz SR2100/N1S user manual download (Page 6 of 23)

Languages: English
Pages:23
You can view the full version and download it in PDF format.
Page 6 of 23
2
ENGLISH
CONNECTIONS
Connection of Remote control Bus: For Marantz AV system
(DR2100, DV2100)
This unit is equipped with the remote control bus function. Connecting
it to Marantz AV system components equipped with REMOTE
CONTROL jacks, such as a CD R player (DR2100) and DVD player
(DV2100), means that these components can be remote controlled
from this unit (SR2100).
Connect the REMOTE CONTROL jacks of this unit to the REMOTE
CONTROL jacks of another component using RCA type pin lead
provided.
To operate the SR2100 in the SYSTEM mode, the leads from the
other components must be connected to the SR2100.
The lead from OUTPUT terminal of other component is connected to
INPUT terminal of the SR2100. Please refer below.
Note:
If the component connected with the REMOTE CONTROL jacks
has an
INT/EXT/SYSTEM
switch on the rear panel, set the switch
to
SYSTEM
position.
Connection of Remote control Bus: For Marantz Models or
without connecting any component (Single use)
This unit is equipped with the REMOTE CONTROL bus function. By
connecting it to Marantz system components equipped with remote
control jacks, such as a CD player and MD player, these components
can be remote controlled from this unit. The system control switch
must be set to
INT
position for single use (no connection to other
components).
Connect the REMOTE CONTROL jacks of this unit to the REMOTE
CONTROL jacks of another component using RCA type pin lead
provided. Please refer below.
Note:
If the component connected with the REMOTE CONTROL jacks
has an
INT/EXT
switch on the rear panel, set the switch to
EXT
.
Connection of Remote control Bus: For use in combination
with Marantz AV system
If you connect this unit to the Marantz AV system component, the
system control switch must be set to
SYSTEM
position.
If other components which are not Marantz AV system are connected,
the system control switch must be set to
INT
position.
Therefore, components other than Marantz AV system are controlled
by their own remote controls.
Connect the REMOTE CONTROL jacks of this unit only to the
REMOTE CONTROL jacks of Marantz AV system, using RCA type
pin lead provided. Do not connect the remote control cable to the other
models. Please refer below.
Connection of SYSTEM IN/OUT Bus: For Marantz AV system
(DR2100, DV2100)
The SYSTEM IN/OUT terminal is for AUDIO signal input and output.
To use the remote control in the SYSTEM mode (system control
switch set to SYSTEM position), be sure to connect the AUDIO
terminals of the SYSTEM IN/OUT jacks to those of the other
component.
You can also use the terminals AUX 1, 2, 3, 4 in the SYSTEM mode.
These terminals are used with Marantz models or components of
other brands. Please refer to the following figure. Be sure to set the
system control switch to
SYSTEM
position.
Note:
If these components are to be stacked, always observe the
stacking order shown in this illustration, that is, the receiver on top,
the CD R player in the middle and the DVD player on the bottom.
Be sure to set the main power switches of the DR2100 and DV2100
ON.
Connection of Audio IN/OUT: For other models
The connections for audio inputs and outputs of other models are
connected to the individual terminals, CD, CD R, MD or AUX 1.
Please refer to the figure on next page. In this situation, the system
control switch must be set to
INT
position.
Sample
This manual is suitable for devices