You can view the full version and download it in PDF format.
Page 39 of 44
NAD IPD 2
The NAD IPD 2 has its own remote control - the DR 1.
When using the DR 1
to command your iPod player docked in the NAD IPD 2, you have to refer to
your iPod player’s own display screen to make full use of its feature; there is
no OSD at this condition. However, any time you press AVR 4’s [
] on the front panel, the “Menu Select” OSD comes up.
If you select
“iPod Menu” at this “Menu Select” option, the NAD IPD 2 gets manually
The control of the NAD IPD 2 will then again be done through
the T 758 using the applicable front panel control buttons or AVR 4 buttons
while referring to the OSD; the NAD IPD 2 will not respond to any DR 1
commands at this stage.
For you to control the NAD IPD 2 using the DR 1, you have to go to “iPod
Setup” menu (please refer to the item about “iPod Setup” under the
“USING THE T 758 - SETUP MENU” segment of OPERATION section) and
then set “Auto Connect” to “No”.
With this setting, you can then use the
DR 1 to control your iPod player docked in the NAD IPD 2.
Note that if you set “Auto Connect” to “No” while at Source 5 (iPod),
you have to change source and then return to Source 5 (iPod) for the
changed setting to take eﬀect.
REGAIN CONTROL OF NAD IPD 2 USING DR 1 REMOTE CONTROL
In order to switch back control of the NAD IPD 2 from the T 758/AVR 4 to
the DR 1 remote control, follow these steps.
Exit from the iPod Menu by pressing repeatedly [
] until it brings you
to “Menu Select” OSD.
Highlight “iPod Menu” and press [
] to advance to “iPod Menu”.
At “iPod Menu”, press [
] to close iPod menu. DR 1 remote control
regains control of the NAD IPD 2.
In addition to the above commands common to the DR 1, below are the
descriptions of the other DR 1 control buttons.
Press [LIGHT] to turn ON the backlight of your iPod player if it is at idle
Press [MENU] to return to previous option or menu selection
Press [ENTER] to select an option or start playback.
Toggle to initiate repeat mode as follows - repeat one song, repeat all songs
or cancel repeat mode
Toggle to initiate playback in random order. There are three random modes
- Shuﬄe Song, Shuﬄe Album or Shuﬄe Oﬀ.
TO VIEW VIDEOS OR PHOTOS LOADED IN YOUR iPod
Videos or photos uploaded in your iPod can be viewed directly via the
T 758. The following are the steps
Make sure that the “TV Out” setting of your iPod’s Video Settings menu is
at “On” mode and appropriate “TV Signal” is chosen.
Video or photo ﬁle selections and playback procedures are managed
directly from your iPod player and not through the T 758. You must exit
completely from the T 758’s Setup Menu or Menu Select OSD for you
to be able to navigate through your iPod player’s video or photo menu
options. A more direct way is by going to the “iPod Setup” menu and set
“Enabled” to “No”.
With the NAD IPD’s S-VIDEO OUT and AUDIO OUT ports connected to
the T 758’s AUDIO 3/S-VIDEO 1 input or to any other assignable input,
you can now directly enjoy via T 758 your video or photo ﬁle selections
as uploaded in your iPod. Make sure that you select the correct “Source
Number” of the T 758. Note that if “Enabled” from “iPod Setup” is set
to “No”, ensure that Source 5 is enabled and analog audio and video
settings are assigned to “A3” and “S1” respectively.
For other navigation functions, please refer to your iPod player’s owner’s
manual. Depending on the iPod player model, some other functions
maybe controlled using the applicable T 758 navigation controls.
iPod is a trademark of Apple, Inc., registered in the U.S. and other countries.
LISTENING TO YOUR iPod PLAYER
This manual is suitable for devices