White-Westinghouse WFC15K2BW1 user manual download (Page 3 of 10)

Languages: English
Pages:10
You can view the full version and download it in PDF format.
Page 3 of 10
FirstSteps
3 II
Installation
_
: L_IEUNG I_ET
Unpacking and Leveling - Upright
Freezers
_Base
PanelScrews
__Base
Panel
,
W
Hinge
Screws
/
Hinge
Figure 1
I_r_
To
allow
doorto
closeandseal properly,DO NOTlet
fondpackagesextendpastthe
front
of shelves.
Shelf Front
Before
starting
the
freezer,
follow
these
important
first
steps:
Installation
Choose a place that is near a grounded electrical
outlet.
For the most efficient operation, the freezer should be located where surround-
ing temperatures
will not exceed 110°F (43°C). Temperatures
of 32°F (0°C) and
belowwill
NOT affect freezer operation.
Additional compressor heaters are not
recommended.
Allow space around the unit for good air circulation.
Leave a 3 inch (75 mm)
space
on all sides of the freezer for adequate circulation.
Leveling
The freezer must have all bottom corners resting firmly on a solid floor. The floor
must be strong enough to support a fully loaded freezer. Check the cabinet with
a level from side to side. After discarding the crating screws and wood base, level
the cabinet.
To Level Upright Unit:
Once leveled, slightly raise adjustment of front feet so the door closes easilywhen
opened about halfway.
To
Level Chest
Unit:
If needed, add metal or wood shims between feet pads and floor.
Cleaning
Wash any removable parts, the freezerinterior,
and exteriorwith
mild detergent
and warm water. Wipe dry. DO NOT USE HARSH
CLEANERS
ON THESE
SURFACES.
Do not use razor blades or other sharp instruments,
which can scratch
the
appliance surface when removing adhesive labels. Any glue left from the tape
can be removed with a mixture of warm water and mild detergent, or touch the
residue with the sticky side of tape already removed. DO NOT REMOVE THE
SERIAL
PLATE.
Door
Removal
(upright models)
If door must be removed to fit through narrow doorways:
1. Gently lay freezer on its back, on a throw rag or blanket.
2. Remove base panel (some models) by unscrewing
two screws from front of
base panel. (Figure 1)
3. At top of cabinet, remove plastic top hinge cover.
4. Remove screws from top hinge.
5. Remove top hinge from cabinet.
Lift door off lower hinge pin.
6. After door is removed, remove the two screws from bottom hinge.
7. To replace door, reverse above order, and securely tighten all screws to prevent
hinge slippage.
3
Sample