KitchenAid KBCO24LSBX04 user manual download (Page 6 of 32)

Languages: English
Pages:32
You can view the full version and download it in PDF format.
Page 6 of 32
BEVERAGE CENTER
USE
Your new beverage center may make sounds
that your old one
didn't
make. Because
the sounds
are new to you, you might be
concerned
about them. Most of the new sounds are normal. Hard
surfaces,
such as the flooring and surrounding
structures,
can
make the sounds
seem louder. The following
describes
the kinds
of sounds
and what may be making them.
Your beverage center is designed
to run more efficiently
to
keep your food items at the desired temperatures
and to
minimize
energy usage.
The high efficiency
compressor
and
fans may cause your beverage
center to run longer than your
old one. You may also hear a pulsating
or high-pitched
sound
from the compressor
or fans adjusting
to optimize
performance.
Rattling
noises may come from the flow
of refrigerant
or items
stored inside the beverage
center.
As each cycle ends, you may hear a gurgling sound
due to
the refrigerant
flowing
in your beverage center.
You may hear water running into the drain pan when the
beverage
center is defrosting.
You may hear clicking
sounds
when the beverage
center
starts or stops
running.
Temperature Separator (Temperature Display)
The temperature
separator
displays
the current
temperatures
(Fahrenheit
or Celsius) for the upper, middle
and lower zones
(compartments)
of the beverage
center. To adjust the
temperature
settings,
see "Adjusting
Controls"
earlier
in this
section.
Dimmer
Upper
Middle
Lower
"F
i/
!
_ii
iii
!--!
A
B
C
D
E
A. Dimmer
B. Upper zone display
C. Middle zone display
D. Lower zone display
E. Fahrenheit/Celsius
For your convenience,
your beverage center control
is preset at
the factory. When you first install your beverage
center, make
sure that the control
is still preset to the mid-setting
as shown.
_,_
Cotder
OFgm_
Coldest
Adjusting Controls
The mid-setting
indicated
in the previous section
should be
correct for normal usage. The control
is set correctly
when
beverages
are as cold as you like.
If you need to adjust the temperature,
wait at least 24 hours
between
adjustments
and then recheck the temperature.
To make the beverage center colder, adjust the control to the next
higher setting.
To make the beverage center less cold,
adjust the
control
to the next lower setting.
To Remove
and Replace
the Racks
1.
Pull the rack forward
until it stops.
Push in on the tabs to
release the rack. Continue
pulling the rack forward
and lift it
up and out of the rack supports.
A
A. Tabs
Sample