KitchenAid KBCA06XPBL01 user manual download (Page 7 of 24)

Languages: English
Pages:24
You can view the full version and download it in PDF format.
Page 7 of 24
3.
Turn the leveling
legs to the right to lower the refrigerator
or
turn the leveling
legs to the left to raise it. It may take
several
turns of the leveling
legs to adjust the tilt of the refrigerator.
NOTE: Having someone
push against
the top of the
refrigerator
takes
some weight
off the leveling
legs. This
makes it easier to adjust the leveling
legs.
J
4.
Open the door and check to make sure that it closes as easily
as you like. If not, tilt the refrigerator
slightly more to the rear
by turning
both front
leveling
screws to the right. It may take
several more turns, and you should turn both leveling
legs the
same amount.
Remove
the Base
Grille:
1.
Open the refrigerator
door.
2.
Using a Phillips screwdriver,
remove the screws attaching
the
base grille to the refrigerator
cabinet.
3.
Pull the base grille toward
you.
A
A, Screws
Replace
the Base
Grille:
1.
Open the refrigerator
door.
2.
Position
the base grille so that the holes are aligned with the
refrigerator
and replace the screws.
REFRIGERATOR
USE
Your new refrigerator
may make sounds
that your old one didn't
make. Because
the sounds
are new to you, you might be
concerned
about them. Most of the new sounds
are normal. Hard
surfaces,
such as the flooring
and surrounding
structures,
can
make the sounds
seem louder. The following
describes
the kinds
of sounds
and what
may be making them.
Your refrigerator
is designed
to run more efficiently
to keep
your food items at the desired temperatures
and to minimize
energy usage. The high efficiency
compressor
and fans may
cause your refrigerator
to run longer than your old one. You
may also hear a pulsating
or high-pitched
sound from the
compressor
or fans adjusting
to optimize
performance.
Rattling
noises may come from the flow of refrigerant
or items
stored inside the refrigerator.
As each cycle ends, you may hear a gurgling
sound due to
the refrigerant
flowing
in your refrigerator.
You may hear water running
into the drain pan when the
refrigerator
is defrosting.
You may hear clicking
sounds
when the refrigerator
starts or
stops
running.
For your convenience,
your refrigerator
control
is preset at the
factory. When you first install your refrigerator, make sure that the
control
is still preset to the mid-setting
as shown.
Adjusting Controls
The mid-setting
indicated
in the previous section
should be
correct for normal usage. The control
is set correctly
when
beverages
are as cold as you like.
If you need to adjust the temperature,
wait at least 24 hours
between
adjustments
and then recheck the temperature.
To make the refrigerator
colder, adjust the control
to the next
higher setting.
To make the refrigerator
less cold, adjust the
control
to the next lower setting.
Sample