Kenmore 10641012100 user manual download (Page 6 of 52)

Languages: English
Pages:52
You can view the full version and download it in PDF format.
Page 6 of 52
Do®r C os ng
Your refrigerator
has two front adjustable
rollers
-- one on the
right and one on the left. If your refrigerator
seems unsteady
or if
you want the doors
to close more easily, adjust the refrigerator's
tilt using the instructions
below:
1.
Move the refrigerator
into its final position.
2.
The two leveling screws
are part of the front roller assemblies
which are at the base of the refrigerator
on either side (see
Graphic
7).
3.
Use a hex-head
socket
wrench
to adjust the leveling
screws.
Turn the leveling
screw to the right to raise that side of the
refrigerator
or turn the leveling
screw to the left to lower that
side. It may take several turns of the leveling screws
to adjust
the tilt of the refrigerator
(see Graphic
7).
NOTE-
Having someone
push against
the top of the
refrigerator
takes some weight
off the leveling
screws and
rollers. This makes it easier to adjust the screws.
4.
Open both doors
again and check to make sure that they
close as easily as you like. If not, tilt the refrigerator
slightly
more to the rear by turning
both leveling
screws to the right. It
may take several more turns,
and you should
turn both
leveling
screws the same amount.
5.
Replace the base grille.
NOTE- Be sure to refasten the Tech Sheet behind the base grille.
Door Removal
Top
Left
Hinge
1.
Do Not Remove Screw
Base Grille
Handle Removal
(Optional)
Top
Right
Hinge
1.
Do Not Remove
Screw
Bottom Hinge
1.
Do Not Remove
Screw
Door
Alignment
1. Leveling
Screw
Read all directions
carefully
before you begin.
IMPORTANT:
If you turn the refrigerator
on before the water line is
connected,
turn the ice maker OFF.
All installations
must meet local plumbing
code requirements.
Use copper
tubing
and check for leaks. Install copper tubing
only in areas where temperatures
will remain above freezing.
Tools required:
Standard
screwdriver,
z,4ein. and _/2in. open-end
wrenches
or two adjustable
wrenches,
%
in. nut driver and drill
bit, hand drill or electric
drill (properly
grounded).
NOTE:
Your refrigerator
dealer has a kit available
with a
Y4
in.
(6.35 mm) saddle-type
shutoff
valve, a union, and copper
tubing.
Before purchasing,
make sure a saddle-type
valve complies
with
your local plumbing
codes.
Do not use a piercing-type
or ¾e in.
(4.76 mm) saddle valve which reduces water flow and clogs more
easily.
Cold water
supply
Connect
the ice maker to a cold water line with water pressure
between
30 and 120 psi. If you have questions
about
your water
pressure,
call your utility
company.
Sample