Jenn-Air JB36NXFXLW00 user manual download (Page 10 of 52)

Languages: English
Pages:52
You can view the full version and download it in PDF format.
Page 10 of 52
Donotusewithwater
thatismicrobiologically
unsafe
orof
unknown
qualitywithout
adequate
disinfection
beforeor
after
thesystem.
WaterFilter
Indicator
(on some
models)
The water filter indicator,
located
on the control
panel, will help
you know when to change the water filter.
A new water filter should
display a reading of 99%. The reading in
the display
will decrease
as the filter
life is used. A replacement
water filter should
be ordered when
"Order Filter" is displayed.
It
is recommended
that you replace the filter when "Change
Filter"
is displayed
or when water flow
to your water dispenser
and/or
ice maker
decreases
noticeably.
See "Changing
the Water Filter"
later in this section.
%
Remaining
Reset
After changing
the water filter, press and hold RESET for
2 seconds
until the status
display
changes to 99%.
Changing
the Water
Filter
The water filter is located
in the base grille below the freezer
compartment
door. It is not necessary
to remove the base grille
to remove the filter.
1.
Remove the filter by pressing the eject button and pulling
straight
out on the filter cap.
NOTES:
Avoid twisting
the cap when
removing
the filter
because
this could
cause the cap to come off. If this occurs,
replace the cap and pull the filter straight
out.
There will be water in the filter. Some spilling may occur.
2.
A. Eject button
B. Filter cap
Remove the cap by turning
it counterclockwise
until it stops.
IMPORTANT:
Do not discard
the cap. It is part of your
refrigerator.
Keep the cap to use with
the replacement
filter.
3.
Align the ridge on the cap with the arrow on the new filter and
turn the cap until it snaps into place.
A
.......
C_
A. Cover
B. O-rings
4.
Remove
the covers from the O-rings.
Be sure the O-rings
are
still in place after the covers
are removed.
5.
Place the cap (removed
in Step 2) on the new filter. Align the
ridge on the cap with the arrow on the filter. Turn the cap
clockwise
until it snaps into place.
A
A. Eject button
B. Arrow
on filter
C. Ridge on cap
6.
Push the new filter into the opening
in the base grille. As the
filter is inserted,
the eject button
will depress.
The eject
button
will pop back out when the filter is fully engaged.
7.
Pull gently on the cap to check that the filter
is securely
in
place.
8.
Discard
the first three batches
of ice produced
after replacing
the filter.
Using
the Ice Maker
Without
a Water
Filter
You can operate
the ice maker without
a water filter. Your ice will
not be filtered.
1.
Remove
the filter by pressing the eject button and pulling
on
the cap. See "Changing
the Water Filter" earlier in this
section.
2.
Remove
the cap by turning
it counterclockwise
until it stops.
IMPORTANT:
Do not discard
the cap.
It is part of your
refrigerator.
Keep the cap to use with the replacement
filter.
3.
With the cap in a horizontal
position,
insert the cap into the
base grille until it stops.
10
Sample