Gibson GFU17F5AW1 user manual download (Page 4 of 23)

Languages: English
Pages:23
You can view the full version and download it in PDF format.
Page 4 of 23
First Steps
3"
AIR SPACE
Installation
DISCARD THE (4) CRATING
SCREWS AND
(2) WOOD
BASES
%
Unpacking
and
Leveling
- Upright
Freezers
SCREWS
_
PLASTIC
N_._b
_UVER
UPRIGHT
FREEZER
DOOR
ADJUSTMENTS
Upright FreezerDoor Removal
Before
starting
the
freezer,
follow
these
important
first
steps:
Installation
Choose a place that is near a grounded
electrical outlet.
The freezer should be located where surrounding
temperatures will not exceed
110°F (43°C). Temperatures
of 32°F (0°C) and below will
NOT affect freezer
operation.
Additional compressor heaters are not recommended.
AIIowspace around the unit for good air circulation.
Leavea 3 inch (75 mm) space
on all sides of the freezer for adequate circulation.
Leveling
The freezer must haveall bottom corners resting firmly on a solid floor, The floor must
be strong enough to support a fully loaded freezer,
NOTE:
It is VERYIMPORTANTfor
your freezer to be level in order to function properly, Ifthe freezer isnot leveled during
installation,
the door may be misaligned and not close or seal properly, causing
cooling, frost, or moisture problems,
To Level Upright
Unit:
After discarding crating screws and wood base, use a carpenter's
level to level the
freezer from front-to-back.
Adjust the plastic leveling feet infront, 1/2 bubble higher,
so that the door closes easily when left halfway open.
To Level Chest
Unit:
If needed, add metal or wood shims between feet pads and floor.
Cleaning
Wash any removable parts, the freezer interior, and exterior with mild detergent
and warm
water.
Wipe
dry.
DO
NOT
USE
HARSH CLEANERS ON
THESE
SURFACES.
Do not use razor
blades or other sharp instruments,
which
can scratch the
appliance surface when removing adhesive labels. Any glue left from the tape can
be removed with a mixture of warm water and mild detergent,
or touch
the
residue with the sticky side of tape already removed.
DO NOT REMOVE
THE
SERIAL PLATE.
Upright
Freezer
Door
Removal
If door must be removed:
1. Lift up plastic hinge cover and fold back.
2. Use a Phillips® screwdriver to loosen and retighten the screws on the top hinge
to insure a secure assembly and prevent hinge slippage.
3. Remove the top hinge from cabinet and lift door off the lower hinge pin.
4. After door is removed, remove the two screws from the bottom
hinge.
5. To replace door, reverse above order.
If!_[=f_'_lJld(H
_
I To
allow
door
to
closeandsealproperly, DO NOT let
foodpackagesextendpastthefront
of shelves,
Shelf Front
4
Sample
This manual is suitable for devices