Frigidaire FCCS071QWA user manual download (Page 4 of 12)

Languages: English
Pages:12
You can view the full version and download it in PDF format.
Page 4 of 12
First
Steps
The following
tools
are required
to assemble and
install
the
casters
to the unit:
A
Wrench (1)
_ _
B
Screws (16)
_
_ _
C
Casters (4)
Caster
Set-up
1. With an assistant,
tilt the unit until
it is
resting
on its
back. Take
care
to protect
the back from
being scratched
during
this
process.
2. Using the wrench
provided
and the sixteen
(16) screws,
install all four (4)
casters
in the tapped
holes in the
bottom
of the unit. Tighten
the screws securely.
3. With an assistant,
tilt the unit back up onto its
casters.
4. To prevent
unintended
movement,
block casters once the unit is in place.
Appliance
Placement
Leave a three (3) inch space on all sides and the back of the cabinet
for ease of installation,
proper air
circulation
and electrical
connections.
Choose a place that
is near a grounded
electrical outlet.
For the
most efficient
operation,
the appliance should be located where surrounding
temperatures
will not drop
below 40OF (5oc)
or exceed
110OF(43oc).
Additional
compressor
heaters are not recommended.
Insulation
The insulated space of this cabinet is sealed to maintain
peak efficiency.
DO NOT drill holes in the
cabinet.
Holes drilled in the cabinet
may destroy that
seal and damage electrical wiring
located in the
insulated space. It may also pierce and damage the sealed refrigeration
system in the
insulated space.
DAHAGED
ELECTRICAL
WIRING
OR WET
INSULATION
CAUSED
BY
DRILLING
WILL
VOID
THE WARRANTY,
Glass Lid Hodels
There are two
(2) glass lids, a smaller
one that
fits in the lower track of the
ice cream freezer
and a larger
one that
fits in the upper track. The lower track has two
(2) round
retaining
studs
and the
upper has four (4) round
retaining
studs.
Install the lower glass first. Again, the lower glass is the smaller of the two. It has a flexible vinyl
seal and a lock plate. The flexible seal should be facing up and positioned
on the end away from
the two
round retaining
studs. Place the panel in the center and slide along the lower track until it
is secure under the two
retaining
studs.
Place the
upper glass panel over the lower glass panel already in place. Slide it over the lower
lid past the flexible
seal. You will notice
a slight
resistance
with the
lower lid gasket.
Slide the
upper
panel under the four studs on the upper
track of the frame.
When properly installed, there is a seal formed
by the flexible vinyl seal between the two glass lids.
4
Sample