Estate TS22AFXKQ07 user manual download (Page 3 of 40)

Languages: English
Pages:40
You can view the full version and download it in PDF format.
Page 3 of 40
INSTALLATIONINSTRUCTIONS
Excessive
Weight
Hazard
Use two or more people to move and install
refrigerator.
Failure to do so can result in back or other injury.
If the ice storage
bin is located
on the door, remove the
temporary
shield from underneath
the ice storage
bin. See
"Ice Maker and Storage
Bin."
Remove packaging
materials.
Do not use sharp instruments,
rubbing
alcohol, flammable
fluids,
or abrasive cleaners to
remove tape or glue. These products
can damage the surface
of your refrigerator.
For more information,
see "Refrigerator
Safety."
NOTE: It
is recommended
that you do not install the refrigerator
near an oven, radiator, or other heat source. Do not install in a
location
where the temperature
will fall below 55°F (13°C).
1/2"
(1.25
crn)
j
II
--
I!
/
7
2" (5.08 cm)i
When
Moving
Your
Refrigerator:
Your refrigerator
is heavy. When moving the refrigerator
for cleaning
or service,
be sure to protect
the floor.
Always
pull the refrigerator
straight out when moving
it.
Do not wiggle
or "walk"
the refrigerator
when trying to move
it, as floor damage
could
occur.
Important
information
to know
about
glass
shelves
and
covers:
Do not clean glass shelves or covers with warm water when
they
are cold. Shelves and covers may break if exposed
to
sudden temperature
changes
or impact,
such as bumping.
For your protection,
tempered
glass is designed
to shatter
into many small, pebble-size
pieces. This is normal. Glass
shelves
and covers are heavy. Use special
care when
removing
them to avoid
impact from dropping.
Explosion
Hazard
Keep flammable
materials
and vapors,
such
as
gasoline,
away
from
refrigerator.
Failure
to
do
so can result
in
death,
explosion,
or fire.
To ensure proper ventilation
for your refrigerator, allow for 1/2"
(1.25 cm) space on each side and at the top. When installing
your
refrigerator
next to a fixed wall, leave 2" (5.08 cm) minimum
on
each side (depending
on your model) to allow for the door to
swing open. If your refrigerator
has an ice maker, allow
extra
space at the back for the water line connections.
E®cff c<s
.......
..........
"
Electrical
Shock
Hazard
Plug
into
a grounded
3
prong
outlet.
Do not
remove
ground
prong.
Do not
use an adapter.
Do not use an
extension
cord.
Failure
to follow
these
instructions
can result
in
death,
fire, or electrical
shock.
Before you move your refrigerator
into its final location,
it is
important
to make sure you have the proper electrical
connection.
Recommended
Grounding
Method
A 115 Volt, 60 Hz., AC only 15- or 20-amp
fused, grounded
electrical
supply
is required.
It is recommended
that a separate
circuit serving only your refrigerator
be provided.
Use an outlet
that cannot
be turned off by a switch.
Do not use an
extension
cord.
NOTE:
Before performing
any type of installation,
cleaning,
or
removing
a light bulb, turn the control (Thermostat,
Refrigerator or
Freezer Control depending
on the model) to OFF and then
disconnect
the refrigerator
from the electrical
source. When you
are finished,
reconnect
the refrigerator
to the electrical
source and
reset the control
(Thermostat,
Refrigerator
or Freezer Control
depending
on the model) to the desired setting.
Sample