You can view the full version and download it in PDF format.
Page 25 of 42
water supply system
several tubing lines, an advanced
valve bank, and a reserve
supply to the ice and water dispenser
at all times. This system
needs to be completely
filled with water when first connected
to an external
water supply system:
Begin filling the tank by pressing
a drinking glass against the water dispenser
Keep the glass in this position
comes out of the dispenser.
It may take
water for about three
minutes to flush the system
of any impurities
empty the glass as necessary).
The water dispenser
has a built-in device that
shuts off the water flow after three minutes of
use. To reset this shutoff device,
simply release the dispenser
The ice maker, ice bin, and dispenser
are located in the top of the freezer
After the refrigerator
properly and has cooled for several hours, the
ice maker can produce ice within 24 hours. It can
fill an ice bin in about two days.
The ice maker produces
four to six pounds of ice
every 24 hours depending
on usage conditions.
is produced at a rate of eight cubes every 75 to 90
Before making ice for the first time, be sure to
prime the water supply
system. Air in new plumbing
lines can result in two or three empty ice maker
if the system
is not flushed,
the first ice cubes may be discolored
or have an
'four ice maker is turned on at the factory so it
can work as soon as you install your refrigerator.
If you cannot connect
a water supply, turn the
ice maker's On/Off switch to Off. Otherwise,
ice maker's fill valve may make a loud chattering
noise when it attempts to operate without water.
by the ice maker's On/
Off power switch. To gain access to the ice maker,
pull the extra shelf out (some models).
switch to the "0" position
to turn it Off and press to
the 'T' position to turn it On.
The ice maker also has a built-in wire signal arm,
stops ice production
the ice bin is full.This
signal arm should not be
used to manually
stop the ice maker.