Crosley CFC07M4AW11 user manual download (Page 3 of 11)

Languages: English
Pages:11
You can view the full version and download it in PDF format.
Page 3 of 11
FirstSteps
!,
Hnstallation
DISCARD
T_E
(4)
CRATIN(,
SCREWSAND (2) WOOD BASES
Unpacking
and
Leveling
- Upright
Freezers
Base
Figure 1
_To
allow door to
chose and seamproperly,
DO NOT let
food packages extend past the front
of sheBves.
SheHfFront
Before
starting
the freezer,
follow
these
important
first
steps:
Installation
*
Choose a pHacethat is neara grounded
eHectricaHoutHet.
*
Forthe most efficient operation, the freezershouHd be Hocatedwhere surround-
ing temperatures wHHnot exceed 110°F (43°C). Temperatures of 32°F (O°C) and
beHowwHHNOTaffect freezeroperation.
AdditionaHcompressorheatersare
not
recommended.
*
A/low space around the unit for good air cimulation.
Leave a 3 inch (75 mm)
space
on aHH
sides of the freezer for adequate drcuHation.
Leveling
The freezer must have aHH
bottom corners resting firmHyon a sofid floor, The floor
must be strong
enough
to support a fuHHy
Hoadedfreezer, Check the cabinet with
a HeveH
from side to side. After discarding the crating screws and wood base, HeveH
the cabinet.
To Level Upright
Unit:
Once HeveHed,
sHightHy
raise adjustment of front feet so the door cHoseseasiHywhen
opened about haHfway.
To LeveJ Chest Unit:
Hfneeded, add metaHor wood shims between feet pads and floor.
C_eaning
*
Wash any removabHeparts, the freezerinterior,
and exteriorwith
miHddetergent
and warm water. Wipe dr},. DO NOT USE HARSH
CLEANERS
ON THESE
SURFACES.
Do not use razor bHades or other sharp instruments,
which can scratch the
appHiancesurface when removing adhesive HabeHs,
Any gHueHeft
from the tape
can be removed with a mixture of warm water and miHddetergent, or touch the
residue with the sticky side of tape aHreadyremoved, DO NOT REMOVE THE
SERIAL
PLATE.
Door
Remova_
(upright
modeJs)
If door must be removed to fit through narrow doorways:
1. GentHyHayfreezer on its back, on a throw rug or bHanket.
2. Remove
base paneH(some modeHs) by unscrewing
two screws from front of
base panel
(Figure 1)
3. At top of cabinet, remove pHastictop hinge cover.
4. Remove screws from top hinge.
5. Remove top hinge from cabinet.
Lift door off Howerhinge pin.
6. After door is removed, remove the two screws from bottom hinge.
7. To repHacedoor, reverse above order, and secureHytighten aHH
screws to prevent
hingesHippage.
Sample