Crosley CFC05M0AW2 user manual download (Page 3 of 24)

Languages: English
Pages:24
You can view the full version and download it in PDF format.
Page 3 of 24
First Steps
3"
Installation
_
: L_IEUNG
REET
Unpackingand Leveling -
Upright Freezers
_Base
PanelScrews
__Base
Panel
,
W
Hinge Screws
/
Hinge
Figure 1
_To
allowdoorto
closeandseal properly,DO
NOT
let
fondpackagesextendpastthe
front
of shelves.
Shelf Front
Before
starting
the
freezer,
follow
these
important
first
steps:
Installation
Choose a place that is near a grounded electrical outlet.
For the most efficient operation, the freezer should be located where surrounding
temperatures will not exceed 110°F (43°C). Temperatures of 32°F (0°C)and below
will NOT affect freezer operation,
Additional compressor heaters are not recom-
mended.
Atlow spacearound
the
unit forgoodaircirculation.
Leavea 3 inch (75 mm) space
on attsides of the freezer for adequate circulation,
Leveling
The freezer must haveall bottom corners resting firmly on asolid floor, The floor must
be strong enough to support afully loaded freezer, Check the cabinet with a levelfrom
side to side. After discarding the crating screws and wood base, level the cabinet.
TO
Level
Upright Unit:
Once leveled, slightly raise adjustment
of front feet so the door closes easily when
opened about halfway.
To
Level
Chest Unit:
If needed, add metal or wood shims between feet pads and floor.
Cleaning
Wash any removable parts, the freezer interior, and exterior with mild detergent
and warm
water.
Wipe
dry.
DO NOT
USE HARSH CLEANERS
ON
THESE
SURFACES.
Do not use razor bladesor other sharp instruments, which can scratchthe appflance
surface when
removing adhesive labels,
Any glue left from
the tape can be
removed with a mixture of warm water and mild detergent, or touch the residue
with the sticky side of tape already removed. DO NOT
REMOVE
THE SERIAL
PLATE,
Door
Removal
(upright models)
If door must be removed
to
fit through narrow doorways:
1, Gently lay freezer on its back, on a throw rug or blanket,
2. Remove basepanel (some models) by unscrewing two screws from front of base
panel, (Figure 1)
3. At top of cabinet, lift up plastic hinge cover and fold
back, (Figure 2)
4. Usea Phillips@screwdriver to loosen and retighten
screws on top hinge to insure a secure assembly and
prevent hinge slippage.
5. Remove top hinge from cabinet.
Lift door off lower
hinge pin,
6. After door is removed, remove the two screws from
bottom hinge,
7. To replace door, reverse above order.
8CREWS
HINGE
I
HINGE COVER
UPRIGHT
FREEZER
DOOR ADJUSTMENTS
Figure2
3
Sample