Crosley CB19G6W00W5 user manual download (Page 12 of 40)

Languages: English
Pages:40
You can view the full version and download it in PDF format.
Page 12 of 40
CONDITION/REASON:
ADJUSTMENT:
REFRIGERATOR too warm
REFRIGERATOR
Control
one setting
higher
FREEZER too warm/too
little
ice
FREEZER Control
one
setting
higher
REFRIGERATOR
too cold
REFRIGERATOR
Control
one setting
lower
FREEZER too cold
FREEZER Control
one
setting
lower
You can control
the amount
of humidity
in the moisture-sealed
crisper.
Depending
on your model, adjust the control
to any
setting
between
FRUIT and VEGETABLES
or LOW and HIGH.
FRUIT
/
LOW
(open) for best storage
of fruits and vegetables
with skins.
VEGETABLES
/
HIGH (closed) for best storage
of fresh, leafy
vegetables.
o
Si£}S® _'SOd®S}
Turning
the Ice Maker
On/Off
To turn the ice maker ON, simply
lower the wire shutoff
arm.
To manually
turn the ice maker OFF, lift the wire shutoff
arm to the
OFF (arm up) position
and listen for the click.
NOTE: Your ice maker has an automatic
shutoff.
As ice is made,
the ice cubes will fill the ice storage
bin and the ice cubes will
raise the wire shutoff
arm to the OFF (arm up) position.
Do not
force the wire shutoff
arm up or down.
Ice Production Rate
The ice maker should
produce
a complete
batch of ice
approximately
every 3 hours.
To increase ice production,
lower the freezer and refrigerator
temperature.
See "Using the Controls."
Wait 24 hours
between
adjustments.
Remember
Allow 24 hours to produce
the first batch of ice. Discard
the
first three batches
of ice produced.
The quality
of your ice will be only as good as the quality
of
the water supplied
to your ice maker. Avoid
connecting
the
ice maker to a softened
water supply. Water softener
chemicals
(such as salt) can damage
parts of the ice maker
and lead to poor quality
ice. If a softened
water supply
cannot
be avoided,
make sure the water softener
is operating
properly
and is well maintained.
Do not store anything
on top of the ice maker
or in the ice
storage
bin.
_®t__
...............
{on s_:_m®modes}
IMPORTANT:
After connecting
the refrigerator
to a water source, flush the
water system.
Press the button on the dispenser
for
5 seconds,
then release it for 5 seconds.
Repeat
until water
begins to flow. Once water begins to flow, continue
depressing
and releasing the dispenser
button (5 seconds
on,
5 seconds
off) for an additional
2 minutes.
This will flush air
from the filter and water dispensing
system.
Additional
flushing
may be required
in some households.
As air is
cleared from the system,
water may spurt out of the
dispenser.
NOTE: After 5 minutes
of continuous
dispensing,
the
dispenser
will stop
dispensing
water to avoid flooding.
To
continue
dispensing,
press the dispenser
button again.
Allow 24 hours for the refrigerator
to cool down
and chill
water. Dispense enough water every week to maintain
a fresh
supply.
Dispensing
Water
1.
Hold a container
under the dispenser
while
pressing the
button.
2.
Release the button to stop dispensing.
£'#
S_
Do not use with water that is microbiologically
unsafe or
of unknown
quality
without adequate
disinfection
before
or after the system. Systems
certified
for cyst reduction
may be used on disinfected
waters that may contain
filterable
cysts.
The water filter is located
in the upper right-hand
corner of the
refrigerator
compartment.
You should
change the water filter at
least every 6 months.
If the water flow to the water dispenser
or
ice maker
decreases
noticeably
before 6 months have passed,
replace the water filter more often.
12
Sample