Jetway 915GCP user manual download

For Devices:Jetway 915GCP   and 1 more
Languages:English
Pages:53
You can view the full version and download it in PDF format.
Page 22 of 53
19
DIMM2 (BANK2+BANK3)
DIMM1 (BANK0+BANK1)
DIMM4 (BANK6+BANK7)
DIMM3 (BANK4+BANK5)
DIMM1 & DIMM3: Dual Channel 1
DIMM2 & DIMM4: Dual Channel 2
NOTE!
When you install DIMM module fully into the DIMM socket the eject tab
should be locked into the DIMM module very firmly and fit into its indention
on both sides.
WARNING!
For the DDR SDRAM CLOCK is set at 200MHz, use only DDR400-compliant
DDR Modules.
When this motherboard operate at 200Mhz, most system will
not even boot if non-compliant modules are used because of the strict timing
issues, if your SDR Modules are not DDR266-compliant, set the DDR
SDRAM clock to 133MHz to ensure system stability.
2-5
Expansion Cards
WARNING!
Turn off your power when adding or removing expansion cards or other system
components. Failure to do so may cause severe damage to both your motherboard
and expansion cards.
2-5-1
Procedure For Expansion Card Installation
1.
Read the documentation for your expansion card and make any necessary hardware or
software setting for your expansion card such as jumpers.
2.
Remove your computer’s cover and the bracket plate on the slot you intend to use.
3.
Align the card’s connectors and press firmly.
4.
Secure the card on the slot with the screen you remove above.
5.
Replace the computer system’s cover.
6.
Set up the BIOS if necessary.
7.
Install the necessary software driver for your expansion card.
Figure 2-4
Sample