Asrock P45XE-WiFiN user manual download (Page 25 of 194)

Pages:194
You can view the full version and download it in PDF format.
Page 25 of 194
2 5
2 5
2 5
2 5
2 5
ASRock
P45XE-WiFiN / P45XE-R / P45XE
Motherboard
English
English
English
English
English
2.8 Onboard Headers and Connectors
2.8 Onboard Headers and Connectors
2.8 Onboard Headers and Connectors
2.8 Onboard Headers and Connectors
2.8 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper
caps over the headers and connectors will cause permanent dam-
age of the motherboard!
FDD connector
(33-pin FLOPPY1)
(see p.2
No. 25 or p.3 No. 24)
Note:
Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE connector (Blue)
(39-pin IDE1, see p.2/3
No. 9)
Note:
Please refer to the instruction of your IDE device vendor for the details.
Serial ATAII Connectors
These six Serial ATAII (SATAII)
(SATAII_1 (Port 0):
connectors support SATA data
see
p.2, No. 17 or p.3, No. 16)
cables for internal storage
(SATAII_2 (Port 1):
devices. The current SATAII
see
p.2, No. 15 or p.3, No. 14)
interface allows up to 3.0 Gb/s
(SATAII_3 (Port 2):
data transfer rate.
see
p.2, No. 18 or p.3, No. 17)
(SATAII_4 (Port 3):
see
p.2, No. 13 or p.3, No. 12)
(SATAII_5 (Port 4):
see
p.2, No. 21 or p.3, No. 20)
(SATAII_6 (Port 5):
see
p.2, No. 19 or p.3, No. 18)
SATAII_5 (Port 4) and SATAII_6 (Port 5) connectors can be used for
internal storage device or be connected to eSATAII connectors to
support eSATAII device. Please read “eSATAII Interface Introduction”
on page 30 for details about eSATAII and eSATAII installation
procedures.
connect
the black end
to the IDE devices
connect the blue end
to the motherboard
80-conductor ATA 66/100/133 cable
SATAII_5
SATAII_3
SATAII_1
(Port 4)
(Port 2)
(Port 0)
SATAII_6
SATAII_4
SATAII_2
(Port 5)
(Port 3)
(Port 1)
the red-striped side to
Pin1
Sample
This manual is suitable for devices