Asrock G PRO user manual download (Page 12 of 25)

Languages: English
Pages:25
You can view the full version and download it in PDF format.
Page 12 of 25
1 2
1 2
1 2
1 2
1 2
2.7 Jumpers Setup
2.7 Jumpers Setup
2.7 Jumpers Setup
2.7 Jumpers Setup
2.7 Jumpers Setup
The illustration shows how jumpers are
setup. When the jumper cap is placed on
pins, the jumper is “SHORT”.
If no jumper
cap is placed on pins, the jumper is “OPEN”.
The illustration shows a 3-pin jumper whose
pin1 and pin2 are “SHORT” when jumper cap
is placed on these 2 pins.
Jumper
Setting
Description
2
1
2
3
PS2_USB_PWR1
Short pin2, pin3 to enable
(see p.6/p.7 item 22)
+5VSB (standby) for PS/2
+5V
+5VSB
or USB wake up events.
Note: To select +5VSB, it requires 2 Amp and higher standby current.
CLRCMOS
Disconnect the power cord,
(see p.6/p.7 item 17)
then short the solder points
to clear CMOS by using
metal material, e.g., a paper
clip.
2.8 Connectors
2.8 Connectors
2.8 Connectors
2.8 Connectors
2.8 Connectors
Connectors are NOT jumpers.
DO NOT place jumper
caps over these connectors.
Connector
Figure
Description
FDD connector
(33-pin FLOPPY1)
(see p.6/p.7 item 10)
Note: Match the red marking on the floppy ribbon cable with Pin1
Solder points
FLOPPY1
Pin1
Red marking
80-Pin ATA 100/133 cable
Connect to the IDE devices
Connect to the motherboard
Black
Blue
IDE1
PIN1
IDE2
PIN1
Primary IDE connector (Blue)
(39-pin IDE1)
(see p.6/p.7 item 7)
Secondary IDE connector (Black)
(39-pin IDE2)
(see p.6/p.7 item 8)
Sample
This manual is suitable for devices