Lynx L27 (2005) user manual download (Page 17 of 42)

Languages: English
Pages:42
You can view the full version and download it in PDF format.
Page 17 of 42
Lighting
Instructions
WARNING!
Before
liqhtinq:
Prior to using grill please remove tie down wires on brass burners.
Inspect the gas supply
piping or hose prior to turning the gas "on". If there is evidence
of cuts
wear, or abrasion,
it must be replaced prior to use.
The replacement
pressure
regulators
and hose assembly
must be the type specified by the man-
ufacturer.
Do not use the grill
if the odor of gas is present.
The
pressure
regulator
and hose
assembly
supplied with the unit must be used. If the unit is L.P., screw the regulator
into the tank
and leak check the hose and regulator
connections
with a soap and water solution
before oper-
ating the grill. Turn all knobs to "off" then SLOWLY turn on the gas supply valve.
Always
keep your face
and body as far away from
the grill as possible
when lighting.
Do not
attempt to "Light" the grill if the odor of gas is present. Call for service. Always wait at least 5 min-
utes before relighting a hot grill.
Grill
Burners
To Light:
Open the lid, push and
hold the ignition button,
%.
on the right side, for 5
seconds.
You should
hear a "clicking" sound.
If not, turn all knobs to
"OFF" and check igni-
tion battery (see page
12).
I Control Knob
I
Turn burner control
knob to light.
If the
burner does not light in
4 seconds,
turn knobs to
"OFF".
f
Ignition Switch
located on right
side
Rotis
Burner
(not all models)
To Light:
I Safety Valve I
Open the lid, push and hold the
I
Button
ignition button for 5
seconds.
You should
Control
/
X%.
hear a "clicking"
sound.I
Knob
I--_._,_.,.
If not, turn all knobs to "OFF" and
(_,
chec
i0nition
atte
,see
a0e
Turn the Rotis control knob to "lite".
"_----_
Hold the safety valve button in for about 4 sec-
onds then Press and hold the igniter button.
This is the only bumer on the
grill with a safety
valve.
Once lit, turn control
knob to desired
set-
ting. If the burner does not light within 4 sec-
onds, release the safety valve button and turn
the control knob to "OFF". Once lit, the rotis
burner should reach cooking temperatures
in
about 1 minute. The orange/red
glow will even
out in about 5 minutes.
If burners will not light after several attempts, see the instructions on match lighting on next page.
Always
wait
at least
5
minutes
before
reliqhtinq
a
hot
burner!
16
Rev. 04/2005
Sample