Ge AEN08LPQ1 user manual download (Page 5 of 52)

Languages: English
Pages:52
You can view the full version and download it in PDF format.
Page 5 of 52
GEAppliances.com
Cool Mode
Usethe Cool mode at Low, Med, High
or
Auto
Fan
Speed
for cooling. Usethe Temperature Increase •
/
Decrease •
padsto set the desired temperature
between 64°F and 86°F in 1% increments.
An electronic thermostat is usedto maintain the room
temperature. The compressorwill cycle on
and off to keepthe room at the set levelof comfort.
Setthe thermostat at a lower number and the indoor
air will become cooler.Setthe thermostat at a higher
number and the indoor air will become warmer.
NOTE: If the air conditioner
is off and is then turned
on
while set to a Cool setting or if turned
from
a fan
setting to a Cool setting, it may take approximately
3 minutes
for the compressor
to start and cooling to
begin.
Cooling
Descriptions
For
Normal Cooling-Select the Cool mode and
High or Mealfan with a middle set temperature.
For Maximum Cooling-Select the Cool mode
and High fan with a lower set temperature.
For Quieter & Nighttime Cooling-Select the
Cool mode and Low fan with a middle set
temperature.
Do Not Operate
in Freezing Outdoor
Conditions
Thiscool-only air conditioner was not designed for
freezing outdoor conditions. It must not be usedin
freezing outdoor conditions.
Energy
Saver
Mode
Controls the fan.
ON--The
fan will cycle on and off with the
compressor.
This results in wider
variations
of room
temperature
and humidity.
Normally
used when
the
room
is unoccupied.
NOTE: The fan may continue
to
run for a short time after the compressor
cycles off.
OFF--The
fan runs all the time, while the compressor
cycles on and off.
Fan Only
Mode
Use the Fan Only Mode at Low,
Med
or High fan
speed to provide air circulation
and filtering
without
cooling. Since fan only settings do not provide cooling,
a Set temperature
cannot
be entered. The room
temperature
will appear
in the display.
NOTE:
Auto Fan Speedcannot be usedwhen in the
Fan
Only Mode.
Auto
Fan
Speed
Set to Auto fan speedfor the fan speedto
automatically set to the speed needed to provide
optimum comfort settings with the set temperature.
If the room needsmore cooling, the fan speed
will automatically increase.Ifthe room needs less
cooling, the fan speedwill automatically decrease.
NOTE:Auto Fan Speedcannot be used when in the
Fen
Only Mode.
Air
Direction
Usethe leversto adjust the air direction left and right.
Fingertip pressureon the louver banks adjuststhe air
direction up or down.
Remote
Control
To ensure proper operation, aim the remote
control at the signal receiver on the air
conditioner.
Hake
sure nothing is between the air conditioner
and the remote control that could block the
signal.
The remote control signal has o range of
up to 20 feet.
Make sure batteries are fresh and installed
correctly as indicated on the remote control.
Remote contains o magnet allowing it to attach
to metal surfaces.
Sample
This manual is suitable for devices