Ge AEL05LPL1 user manual download (Page 6 of 48)

Languages: English
Pages:48
You can view the full version and download it in PDF format.
Page 6 of 48
About
the
controls
on
the air
conditioner.
Do Not
Operate
in Freezing Outdoor
Conditions
Thiscool-only air conditioner was not designed for
freezing outdoor conditions. It must not be used in
freezing outdoor conditions.
Remote
Control
To ensure proper operation, aim the remote
control at the signal receiver on the air
conditioner.
Make sure nothing is between the air conditioner
and the remote control that could block the
signal.
The remote control signal has a range of
up to 20 feet.
Make sure batteries are fresh and installed
correctly as indicated on the remote control.
Remote contains a magnet allowing it to attach
to metal surfaces.
6
Cool Mode
Usethe Cool mode at
Low, Med, High
or
Auto Fan
Speed
for cooling. Usethe
Temperature increase
A
/Decrease
T padsto set the desired temperature
between 64% and 86% in !% increments.
An electronic thermostat is usedto maintain the room
temperature. The compressorwill cycle on and off
to keepthe room at the set level of comfort. Setthe
thermostat at a lower number and the indoor air will
become cooler.Setthe thermostat at a higher number
and the indoor air will become warmer.
NOTE:If the air conditioner is off and is then turnedon
while set
to
a
Coo/setting
or if
turned
from a fan setting
to a
Cool setting,
it
may
takeapproximately
3
minutes
for the
compressor
to
start
and
cooling
to begin.
Cooling
Descriptions
For Normal
Cooling-Select the Cool mode and
High
or
Med
fan with a middle set temperature.
For Maximum
Cooling-Select the Cool mode
and
High
fan with a lower set temperature.
For Quieter
and
Nighttime
Cooling-Select the
Cool mode and
Low
fan with a middle set
temperature.
Energy
Saver
Mode
Controls the fan.
ON--The
fan will cycle on and off with the
compressor. This results in wider variations of room
temperature and humidity. Normally usedwhen the
room is unoccupied.
NOTE:Thefan may
continue
to
run for a short time after the compressorcyclesoff.
OFF--The
fan runs all the time, while the compressor
cycles on and off.
Fan
Only
Mode
Usethe Fan Only Mode at Low, Med or High fan
speedto provide air circulation and filtering without
cooling. Sincefan-only settings do not provide
cooling, a Set temperature cannot be entered.The
room temperature will appear
in the display.
NOTE:Auto Fan Speedcannot be used when in the
Fan Only Mode.
Auto Fan Speed
Set to Auto fan speedfor the fan speedto
automatically set to the speed needed to provide
optimum comfort settings with the set temperature.
If the room needsmore cooling, the fan speed
will automatically increase.If the room needs less
cooling, the fan speedwill automatically decrease.
NOTE:Auto Fan Speedcannot be used when in the
Fan Only Mode.
Power
Outage
Recovery
Feature
In the case of a power outage or interruption, the
unit will automatically restart in the settings last
used after the power is restored. Ifthe
Delay 1-24hr
feature was set, it will resume countdown. You may
need to set a new time if desired.
Sample