Ge AEH06LSQ1 user manual download

You can view the full version and download it in PDF format.
Page 6 of 48
About
the
controls
on
the
air
conditioner.
Do Not Operate
in
Freezing
Outdoor
Conditions
Thiscool-only air conditioner was not designed for
freezing outdoor conditions. It must not be used in
freezing outdoor conditions.
Remote
Control
To ensure proper operation, aim the remote
control at the signal receiver on the air
conditioner.
Hake
sure nothing is between the air conditioner
and the remote control that could block the
signal.
The remote control signal has o range of
up to 20 feet.
Make sure batteries ore fresh and installed
correctly as indicated on the remote control.
Remote contains o magnet allowing it to attach
to metal surfaces.
6
Cool Mode
Usethe Cool mode ot
Low,
Med,
High
or
Auto Fan
Speed
for cooling. Usethe
Temperature
Increase
/Decrease
podsto set the desired temperature
between 64°F and 86°F in Z% increments.
An electronic thermostat is usedto rnointointhe room
temperature. The compressorwill cycle on und off
to keepthe room at the set level of comfort. Setthe
thermostat at o lower number and the indoor air will
become cooler.Setthe thermostat at o higher number
and the indoor air will become wormer.
NOTE:If
the air conditioner
is off
and
is then turnedon
while
set
to
o Cool setting
or if turnedfrom
o
fan
setting
to
o Cool setting,
it may take
approximately
3 minutes
for the
compressor
to
start and cooling
to begin.
Cooling
Descriptions
For Normal Cooling-Select
the
Cool
mode and
High
or
F/ed
fan with o middle set temperature.
For
Maximum
Cooling--Select
the
Cool
mode
and
High
fan with o lower set temperature.
For Quieter
and
Nighttime Cooling-Select
the
Cool
mode and
Low
fan with o middle set
temperature.
Energy
Saver
Mode
Controls the fan.
ON--The
fan will cycle on and off with the
compressor. This results in wider variations of room
temperature and humidity. Normally usedwhen the
room is unoccupied.
NOTE:Thefan may
continue
to
run for o short time after the compressor cyclesoff.
OFF--The
fan runs oil the time, while the compressor
cycles on and off.
Fan Only
Mode
Usethe Fan Only Node at Low, Ned
or
High fan
speedto provide air circulation and filtering without
cooling. Sincefan-only settings do not provide
cooling, o Set temperature cannot be entered. The
room temperature will appear
in the display.
NOTE:Auto Fan Speed
cannot
be usedwhen in the
Fan Only Mode.
Auto
Fan
Speed
Set to Auto fan speedfor the fan speedto
automatically set to the speed needed to provide
optimum comfort settings with the set temperature.
If the room needsmore cooling, the fan speed
will automatically increase.If the room needs less
cooling, the fan speedwill automatically decrease.
NOTE:Auto Fan Speed
cannot
be used when in the
Fan Only Mode.
Power
Outage
Recovery
Feature
In the case of o power outage or interruption, the
unit will automatically restart in the settings lost
used offer the power is restored. Ifthe
Delay
1-24hr
feature was set, it will resume countdown. You may
need to set o new time if desired.
Sample