Frigidaire FAA053M7A1 user manual download (Page 6 of 9)

Languages: English
Pages:9
You can view the full version and download it in PDF format.
Page 6 of 9
Using
Air
Conditioner
_r!__[€
To reduce the risk of fire, electric shock, or injury to persons, read
the IMPORTANT SAFETYINSTRUCTIONSbefore operating this appliance.
NOTE:-If the air conditioner
is turned off,
wait
3 minutes
before
restarting.
This
allows pressure inside the compressor to
equalize.
Failure
to
follow
these
instructions
may
cause
inefficient
operation.
To begin operating
the air conditioner,
follow
these steps:
1.
Plug in the
air conditioner.
(To prevent
electrical
hazards, do
not
use an
extension cord or an adapter plug.)
2.
Set the exhaust vent to the CLOSED position.
3.
Set the thermostat
to the highest number (coldest or cooler setting).
4.
Set the selector control to the highest FAN-or COOL setting (see below).
5.
Adjust the louvers for comfortable
air flow (see Air Directional
Louvers).
6.
Once the room has cooled, adjust the thermostat
to the setting you find most
comfortable.
Review the "Air Conditioner
Features" section for other settings.
Air Conditioner
Features
The
controls
featured
in
this manual
are representational
of
the
many models
available.-Your model may offer slightly different
features.
Selector
Control
The selector control turns the unit on or off and allows a choice of either cooling
room air, circulating room air at the existing temperature,
or heating room air (some
models).
COOL/FAN
Operate COOL/FAN models according to the following
suggestions:
ON/OFF or OFF= Turns air conditioner
on and off.
HIGH-COOL = Maximum
cooling speed. Begin operation
of the air conditioner
in this mode.
MEDIUM-COOL-(some models) = Fan runs slower for moderate cooling speeds.
LOW-COOL = Fan runs slow for quiet operation when maximum cooling is not
needed.
HIGH-FAN = Maximum air circulation without
cooling.
MEDIUM-FAN-(some models) = Moderate air circulation without
cooling.
LOW-FAN-= Slow air circulation without
cooling.
H EAT-(some
models)
The HEAT-selection provides quiet, efficient circulation of warm air. Turn the selector
to the HEAT-setting and set the thermostat
at number
1, or lowest setting. When
the
HEAT-setting
is
selected,
the
thermostat
maintains
the
temperature
by
automatically
turning the heater on and off in response to room temperature.
The
fan runs continuously
to circulate air in the room.
Once the room is warm, adjust the thermostat to a higher number. Higher numbers
provide less heat, or cooler temperatures.
A slight heat odor may come from the unit when first switching
to HEAT after the
cooling season is over. This odor, caused by fine dust particles on the heater, will
disappear quickly.
Sample