Frigidaire FAA053M7A1 user manual download (Page 5 of 9)

Languages: English
Pages:9
You can view the full version and download it in PDF format.
Page 5 of 9
Front
Installation
Some models
are shipped
in a
removable
sleeve, please follow
the supplied
Installation Instruction before installing the Decorative front and accessories.
Installing
the
Vent
Control
(on some models)
The vent control handle is included in the decorative front kit (Fig. 3). The handle
must be installed before the decorative front
is attached. See illustration below.
1.
Insert the handle with the "etchings (Vent/Air)"
facing to the left.
2.
Slip the black door extension into the split at the end of the handle.
3.
For ease of
assembly, push the handle in while
pressing the door extension
against the foam until the two
pieces lock together.
4.
Move handle in and out to be sure vent is operating
properly.
Installing
Dial
Plate
and
Front
Frame
Some models require installation of the dial plate and the front
panel of the air
conditioner
included in a decorative kit. To assemble, follow these steps.
Remove control knobs from front kit (some models).
Carefully remove protective film
from the front of the dial plate
(some models).
Line up holes on dial plate with the correct control stems and push dial plate to
control panel surface.
While holding dial plate in place
install control
knobs on protruding
stems (Fig. 1).
STEP 1:
INSTALLING
DIAL
PLATE AND
CONTROL
KNOBS:
STEP 2:
INSTALL
DECORATIVE
FRONT
TO CABINET:
FIG. 1
FIG. 2
Decorative
Front
On some models, before installingthe front frame, removethe tilt panel. Graspthe panel on both sidesand gently pull to release.
Position the top of the decorative front over the top flange of the case, and align the tabs with the slots in the case(Fig. 2).
As you install the front frame to the unit be sure the vent handle is positioned through the front in the proper location.
Carefully pull down on the front to
engage the top tabs, while pushing
the front over the case to ensure
proper alignment.
The side tabs will "click" when
front is seated.
Install front retaining screw(s)
behind the filter handle or filter
& panel (Figs. 3 & 4).
On some models, then add filter & panel.
FIG. 3
FIG. 4
Sample