Craftsman 358740160 user manual download (Page 20 of 44)

Languages: English
Pages:44
You can view the full version and download it in PDF format.
Page 20 of 44
20
TECHNICAL DATA
The computed kickback angle (CKA) listed on your saw and listed in the CKA table below
represents angle of kickback your bar and chain combinations will have when tested in accordance
with CSA (Canadian Standards Association) and ANSI standards. When purchasing replacement
bar and chain, considerations should be given to the lower CKA values. Lower CKA values
represent safer angles to the user, higher values indicate more angle and higher kick energies.
Computed angles represented indicate total energy and angle associated without activation of the
chain brake during kickback. Activated angle represents chain stopping time relative to activation
angle of chain break and resulting kick angle of saw. In all cases lower CKA values represent a
safer operating environment for the user.
The following guide bar and chain combinations meet kickback requirements of CSA Standards
Z62.1, Z62.3, & ANSI B175.1 when used on saws listed in this manual. Use of bar and chain
combinations other than those listed is not recommended and may not meet the CKA requirements
per standard.
Model
Guide Bar
Chain
CKA without
chain brake
Part No.
Length (in/cm)
358.740160
586514501
16/40
UC83G 56DL
45°
358.740180
580678801
18/45
UC83G 62DL
45°
Type
In
In (mm)
In (mm)
°
°
°
In (mm)
In (mm) : dl
UC83G
0,375
0,050 (1,3) 5/32 (4,0)
85
°
30
0
0,025 (0,65)
16 (40) : 56
18 (45) : 62
EMISSION CONTROL WARRANTY STATEMENT
IMPORTANT: This product is compliant with U.S. EPA Phase 3 regulations for exhaust and
evaporative emissions. To ensure EPA Phase 3 compliance, we recommend using only genuine
replacement parts. Use of non-compliant replacement parts is a violation of federal law.
YOUR WARRANTY RIGHTS AND OBLIGATIONS: The U.S. Environmental Protection Agency,
California Air Resources Board, Environment Canada and
Sears Brands Management
Corporation, U.S.A. (Sears)
are pleased to explain the emissions control system warranty on your
year
2017
and later off-road engine. In California, all small off-road engines must be designed, built,
and equipped to meet the State’s stringent anti
-smog standards.
Sears
must warrant the emission
control system on your small off-road engine for the periods of time listed below provided there has
been no abuse, neglect, or improper maintenance of your small off-road engine.
Your emission control system includes parts such as the carburetor, the ignition system and the fuel
tank, line, and cap. Where a warrantable condition exists,
Sears
will repair your small off-road
engine at no cost to you. Expenses covered under warranty include diagnosis, parts and labor.
MANUF
ACTURER’S WARRANTY COVERAGE: If any emissions related part on your engine (as
listed under Emissions Control Warranty Parts List) is defective or a defect in the materials or
workmanship of the engine causes the failure of such an emission related part, the part will be
repaired or replaced by
Sears
.
OWNER’S WARRANTY RESPONSIBILITIES: As the small off
-road engine owner, you are
responsible for the performance of the required maintenance listed in your instruction manual.
Sears
recommends that you retain all receipts covering maintenance on your small off-road engine,
but
Sears
cannot deny warranty solely for the lack of receipts or for your failure to ensure the
performance of all scheduled maintenance. As the small off-road engine owner, you should be
aware that
Sears
may deny you warranty coverage if your small off-road engine or a part of it has
failed due to abuse, neglect, improper maintenance, unapproved modifications, or the use of parts
not made or approved by the original equipment manufacturer. You are responsible for presenting
your small off-road engine to a
Sears
authorized repair center as soon as a problem exists.
Warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days. If
you have any questions regarding your warranty rights and responsibilities, you should contact your
nearest authorized service center.
Call
Sears
at
1-888-331-4569
or send e-mail correspondence to emissions@husqvarnagroup.com.
Sample