Admiral AGD4475TQ1 Installation Instructions download (Page 3 of 20)

Languages: English
Manual type:Installation Instructions
Pages:20
Instant delivery to e-mail
You can buy the full version and download it in PDF format instantly.
Page 3 of 20
Explosion
Hazard
Keep
flammable
materials
and
vapors, such
as
gasoline,
away from
dryer,
Place
dryer
at least
18
inches
(46 cm) above
the floor
for a garage
installation.
Failure
to
do
so can result
in
death,
explosion,
or fire.
You will need
A location
that allows for proper exhaust
installation.
A gas
dryer must be exhausted
to the outdoors.
See "Venting
Requirements."
A grounded
electrical
outlet located within 2 ft (61 cm) of
either side of the dryer. See "Electrical
Requirements."
A sturdy floor to support
the dryer and a total weight
(dryer
and load) of 200 Ibs (90.7 kg). The combined
weight
of a
companion
appliance
should also be considered.
A level floor with
a maximum
slope
of 1" (2.5 cm) under entire
dryer. (If slope is greater than 1" [2.5 cm], install Extended
Dryer Feet kit, Part No. 279810.) Clothes
may not tumble
properly
and models
with automatic
sensor cycles
may not
operate
correctly
if dryer is not level.
Do not operate
your dryer at temperatures
below 45°F (7°C). At
lower temperatures,
the dryer might not shut off at the end of an
automatic
cycle. Drying times
can be extended.
The dryer must not be installed or stored in an area where it will be
exposed to water and/or
weather.
Check code requirements.
Some codes limit, or do not permit,
installation
of the dryer in garages,
closets,
mobile homes
or
sleeping
quarters.
Contact your local building
inspector.
NOTE: No other fuel-burning
appliance
can be installed in the
same closet as a dryer.
Installation
Clearances
The location
must be large enough to allow the dryer door to
open fully.
22%"
_,m!l
433/8'
...................
_m--($7.8or,) d4_
"273/4"_
___
*27%"_-
(70.5cm)
_
(70.5cm)
c
29"
_"_3.06
crn)
D
A. Small Opening Side-Swing Door
B. Large Opening Side-Swing Door
C.
Wide Opening Side-Swing Door
D.Wide Opening Hamper Door
*Most installations
require a minimum
5" (12.7 cm) clearance
behind the dryer for the exhaust
vent with elbow. See "Venting
Requirements."
Installation
spacing
for
recessed
area or closet
installation
The following
spacing
dimensions
are recommended
for this
dryer. This dryer has been tested for spacing
of 0" (0 cm)
clearance
on the sides and rear. Recommended
spacing
should
be considered
for the following
reasons:
Additional
spacing
should be considered
for ease of
installation
and servicing.
Additional
clearances
might be required for wall, door and
floor moldings.
Additional
spacing
should
be considered
on all sides of the
dryer to reduce noise transfer.
For closet installation,
with a door, minimum
ventilation
openings
in the top and bottom
of the door are required.
Louvered
doors with equivalent
ventilation
openings
are
acceptable.
Companion
appliance
spacing should also be considered.
(45.7
cm)
III
-=g
_114"
max.
_
--
_H
48in?*
°1°
I1:1
_
(310cm')
24in.
2.
--
(155crn2)
1"-_ _
29"_t _-1"
-*II"*F =7_z."_
s"*_
(2.Scrn)
(73.66crn)
(2.5cm)
(2.5cm)
(70.5cm)
(12.7cm)
A
B
A. Recessed area
B. Side view
- closet
or confined area
C.Closet door with vents
3,,_
_.6cm)
__
3"*
(7.6cm)
7
*Required spacing
Sample