Hitachi C6U Service Manual download

Manual type:Service Manual
Pages:5
You can view the full version and download it in PDF format.
Page 1 of 5
MODELS
C 6U/C 7U
-
1
-
1. PRECAUTIONS IN SALES PROMOTION:
In the interest of promoting the safest and most efficient use of the Models C 6U and C 7U Circular Saws
by all of our customers, it is very important that at the time of sale the salesman carefully ensures that
the buyer seriously recognizes the importance of the contents of the Handling Instructions, and fully
understands the meaning of the precautions on the Nameplate attached to each tool.
1-1. Handling Instructions:
Although every effort is made in each step of design, manufacture, and inspection to provide protection
against safety hazards, the dangers inherent in the use of any electric tool cannot be completely elimi-
nated. Accordingly, general precautions and suggestions for the use of electric power tools, and specific
precautions and suggestions for the use of the Circular Saw are listed in the Handling Instructions to
enhance the safe, efficient use of the tool by the customer. Salesmen must be thoroughly familiar with
the contents of the Handling Instructions to be able to offer appropriate guidance to the customer
during sales promotion.
1-2. Cautions on Nameplate:
Each tool is provided with a Nameplate which lists the following basic safety precautions in the use of the
tool.
(1)
For F.R. Germany, Switzerland and Austria.
ACHTUNG
z
Bedienungsanleitung vor Inbetriebnahme lesen.
(2)
For France
ATTENTION
z
TRES IMPORTANT: Lire avec attention la notice
dā€™ utilisation.
(3)
For Other Countries:
CAUTION
z
Read thoroughly HANDLING INSTRUCTIONS
before use.
2. PRECAUTIONS IN DISASSEMBLY AND REASSEMBLY:
The disassembly and reassembly procedures for the Models C 6U and C 7U are essentially the same. The
circled numbers in the descriptions below correspond to the item numbers in the parts list and exploded
assembly diagram for the Model C 6U. During disassembly and reassembly, and at all other times as well,
sufficient care must be exercised in handling to ensure that there is no deviation in the flatness of the
bottom surface of the base and in its perpendicularity with relation to the saw blade.
2-1. Disassembly:
(1)
Prior to attempting further disassembly, ensure without fail that the TCT Saw Blade
13
is removed
to prevent damage to its cutting edge, and to avoid possible serious accident.
(2)
Remove the Safety Cover
9
:
First, disconnect the Return Spring
8
from the Safety Cover
9
Then, loosen the two M4 x 10
Seal Lock Flat Hd. Screws
11
and take off the Bearing Cover
10
. The Safety Cover
9
can then
be removed.
Sample
This manual is suitable for devices